-36V 500W Brushless Hall Motor Controller Balanced Car Driver Board G0U4

Description

Features:
SMT process, .
brushless motor driver board.
Operating voltage: to 36V; operating current ≤15A.
With speed regulation function, 0.1V-5V speed voltage.
Stall , over-current , enable control, steering control and speed control signal.
Specifications:
Operating Voltage: DC12-36V
Operating Current: ≤15A
Drive : ≤500W
Speed Voltage: 0.1V-5V
Operating Temperature: -40~85°C
Humidity: ≤90%RH
Stall : Yes
Enable Control: Yes
Over-current : Yes
Steering Control: Yes
Speed Control Signal: Yes
Size: 63 * 42 * 17mm
Weight: 30g
terminal OUT:
VCC (positive )
GND (negative )
MC (motor phases W)
MB (motor phases V)
(motor phases U)
SET for the control side:
GND  control terminal ground
the governor end 0-5V(corresponding to 10% of motor speed - 100%)
ZF   reversing control(connected to 5V or ground can change the motor rotation direction)
M   tachometer pulse output(depending on the number of motor poles corresponding to the number of pulses per revolution of the output number)
EL  enable control terminal(connected to 5V or ground running then 5V, grounding the motor stops)
HALL for the Hall terminals:
5V, Hall positive
Ha, Hall signal
Hb, Hall signal
Hc, Hall signal
GND, Hall negative
Note:
Due to different Hall motor manufacturers, the Hall line order may show difference from the pictures, you need to adjust the sequence.
If the line sequence is wrong, it will not work as expected, such as -up abnormally, with large current or even burn the driver board.
Tips:
If you use less than
60W
, without additional heat sink; please make sure to add heat sink when exceed 60W.
When installing the heat sink, you pay attention to the insulation for 6pcs MOS on the back of module. It will damage the driver board permanently without insulation.
Package List: E1880
1 * Brushless Motor Controller